About mbutorac1

mbutorac1 · 07-10-2007

Howdy,I would like to use LACP wih 2 NIC's on a server connecting to a 6509 blade. Problem seems to be that you can't put a port-channel interface in a vlan. Am I reading the docs correctly? Is there a workaround for this other than haveing a bunch o...

mbutorac1 · 06-11-2007

Howdy,For some reason, I now get password authentication failure with the ssh2 server. Username & pasword allow me in with ASDM. SSH used to work last week.6 Jun 11 2007 10:58:41 315011 172.20.199.199 SSH session from [snip] disconnected by SSH ser...

mbutorac1 · 03-26-2007

Howdy,Has anyone had any experience with implementing Cisco Works in a Disaster Recovery environment? Any issue with moving the data to another server? another IP address? another machine name?Thanks,Mike

mbutorac1 · 07-10-2007

That did the trick! Thanks!

mbutorac1 · 07-10-2007

Sounds like the old joke, you can tune a piano, but you can't tune a fish (couldn't resist!)So, just 802.1q trunks and no port-channel?

mbutorac1 · 07-10-2007

Here is what happens when I try to add vlan access to port-channeled ports:Command rejected (Port-channel2, Gi7/1): Either port is L2 and port-channel is L3, or vice-versaS3EDC03B(config-if-range)#This looks like I need more L3 in the mix to me.

mbutorac1 · 07-10-2007

Can you expand on your answer? Trunking is normally switch to switch, not host to switch.Mike

mbutorac1 · 07-10-2007

Can't remember the exact reference, but anyway, here is what happens if you try itinterface Port-channel2 description Wintel Server no ip address shutdown S3EDC03B#conf tEnter configuration commands, one per line. End with CNTL/Z.S3EDC03B(...

Member Since	‎03-26-2007 11:21 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	11

User Statistics

User Activity

Host LACP on a 6500 w/vlans

ASA SSH2 Server failed

Cisco Works & Disaster Recovery

Re: Host LACP on a 6500 w/vlans

Re: Host LACP on a 6500 w/vlans

Re: Host LACP on a 6500 w/vlans

Re: Host LACP on a 6500 w/vlans

Re: Host LACP on a 6500 w/vlans