Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How do you debug VPN's on the FTD's now? It seems that Cisco has taken a step into the useless with the FTD's, and debugging was always a Cisco strong point.I have active/standby FTD pair controlled by an FMC, all on version 7.0.1I can now get a vpn...
Hi all, hope you can help.
I've normally been the one to get lumbered with VPN's, and I'm simulating a layout (in GNS3) for someone to view prior to configuring the new kit.
There'll be several remote and mobile sites, so my plan was an IPSEC tunn...
Hi all.
I'm trying to get a default route published from one side of our network to another. We have a single EIGRP AS across two geographical areas. This is joined in the middle by a new device (installed by an outside consultancy, which I've now...
Hi all. I've been asked if I can setup a network for a weekend event. To achieve their requirements I'll need to guarantee 1 device (or VLAN) a minimum level of bandwidth. Below is a list of stipulationsThe venue that's been hired has bandwidth of ...
Hi,I have a an issue with a VPN/GRE tunnel. Our edge router is sending alerts as follows03/10/2013 10:24 : DUAL-5-NBRCHANGE 3193: Oct 3 09:24:10.080: %DUAL-5-NBRCHANGE: EIGRP-IPv4 1: Neighbor 192.168.198.141 (Tunnel10) is down: holding time expiredT...
Any Fix though? We have this exact issue, but ONLY on one specific model laptop (Dell Precision). All of our other laptops and desktops (Fujitsu and Lenovo) all work fine.OS is the same build, with same AV/Group Policy same buildAnyconnect is the sa...
Hi, PH1 and PH2 are both up. I've also now shutdown the interfaces Tu0 on both GRE ends, and added the VPC's ip addresses to the interesting traffic, in a bid to complete the ipsec issue first. You'll see the second PH2 as the last output below.
F...
