Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a PIX 515e installed and running and PPTP configed for VPN. Vpn clients connect to the PIX fine but cant see anything on the inside. When we pull up the network neighborhood there isn'ything there. We also tried using the domain name but get a...
I'm setting up a PIX firewall as a VPN server, and was wondering if someone can help me with an example config. Here's the way it's setup, the outside int has a public IP and the inside is NAT'ed. there is a PAT global command on the outside int. The...
My pix 515e FW arrives tomorrow to complete a job and the current setup I was planning on doing will go like this. Router with a single IP address, NAT to inside port of router with a static router created for both directions, then Pix FW PAT on outs...
I have a question to all you Consultants. I've been recently hired to install a PIX 515E firewall, and config the system as well as setup the VPN database. I was wondering in just labor costs what would you charge for this job. All hardware is provid...
I have a question, I'm going to create VLAN's on a 2950 switch. The network i'm doing this on is up and can not be brought down. You guys don't see any great risk in doing this in the middle of the day, or would you wait for the maintenance window?th...
OK have 1 more question. I plan on using ISL on the trunk, and the network I want to segment with VLAN's are all the same subnet. I only want to create VLANS on the physical port face not at a logical level. So can I use the same IP address for each ...
Its a basic setup, I have th 2950 with 4 ports feeding switches downstream, and 1 uplink to a cisco 7260 router. There is no immideiate need to route between the vlans but it is something that I may do at a later time. I'm basically going to use port...
Its very possible that the service provider accidently looped your circuit. I know I've done it many times, and will do it again. When you have 15,000 T1 lined up side by side it's not hard to plug you're net monitoring equipement into the wrong jack...
It is possible that your csu/dsu is dying. The smart jack at your site could have an automatic loopback feature. Which means if the DS1 signal from your router fails the NID automatically loops itself to prevent alarms from traveling up the telco cha...
Scott,you're correct that line code mismatches even at the CO and field card will introduce CRC errors in the span. The reason I tend to lean away from the DACS as the most likely suspect is DACS mappings are very straight forward. What jpoulus didnt...
