Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Here is my portion of ACL List applied on the Controller CPU.- permit 192.168.1.0/24 0.0.0.0 UDP DHCPServer DHCPCLient Any Outbound- Permit 0.0.0.0 192.168.1.0/24 UDPDHCPClient DHCPServer Any InboundThe DHCP server is connected to a Cisco...
I am current setting up a simple wireless network consist of 2 Aironet 1130 AP,1 WLC 2106 and 1 Catalyst 2950 24 ports.I configured the AP Manager and Management interfaces both on the VLAN 30. at the same time I configured Catalyst 2950 Fa0/6 to be ...
Twaite,same encounter as mine. I got a setup like this:Internet-----PIX------L2 Switch----WLC 2106 and 2 1131APs connected directly to the L2 switch.However I created separate Management VLAN and the client ...
Hi Rick,you are right on Layer 2 switch can only have 1 VLAN interface. but i understood from friend of mine that you can configuring spanning tree protocol to go about it. is that true?thanksJ
Your laptop wireless is configure at what modes? b/g? and make sure your AP is configured to either 1 of these modes or both. are you able to "see" the AP's SSID from the laptop?
1. make sure your PC running TFTP server should be between 10.0.0.2 and 10.0.0.302. rename the AP image file in the TFTP folder to c1130-k9w7-tar.default for an 1130 series AP.3. press and HOLD the MODE button while power cycle the AP until the statu...
