Hi,
Can we terminate multiple SIP trunk on Single Ethernet Interface (using sub interfaces) from Service Provider on Cisco 4451-X CUBE?
If yes, then what all would be the limitations/restrictions to implement the same.
Regard's
Anil
Hi My client is having Cisco Works 2000 and he is trying to add second pix in Cisco works but he is facing some issue in that. I have attached the screen shot of the output of error.
Hi Nipun,No, I think you misunderstood the design..Total Sites 3Total CUBE's 6Two CUBE at each siteIn Active Standby mode ( Primary as Active, Secondary as Standby) at each site With CUBE redundant licenses ...
Hi Chris,
These document doesn't say that it is not supported on 3900 series.
it's only says about 4K.
and if you see this document it says PVDM3-32 replacement is PVDM4-32 which again creates confusion.
https://www.cisco.com/c/en/us/products/colla...
Hi Mohammed,
Thanks for your reply, No, actually primarily CUBE will accept the calls for local site but has secondary trunks terminate for other site also, means if anything goes wrong with those site all the calls will be routed to that site. but...