Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm stuck and would appreciate some help.My config is attached. Currently the acls areip access-list extended InsideToOutside_acl10 permit ip any anyip access-list extended OutsideToInside_acl10 permit ip any anyif I change OutsideToInside_acl to...
I would appreciate an example config of how to setup the router without NAT. I found this was possible when I had a PIX 506E but cannot seem to get it working on the ISR. Steps so far.The internal LAB is a /24 subnet of public IP addressescreate a vl...
We've purchased a C1161 and found the GUI is very light in capability, so it is back to the CLI. I would appreciate help. The device has IOS Gibraltar 12.11. a starter - what VPN client software is available for windows 10? We don't want to pay more ...
Just purchased a C1111-8P running Gibraltar. Would like to install a certificate that can be used for https and VPN. Trying to follow the documentation, but got stuck with a 400 Bad Request No required SSL certificate was sent after setting the https...
I would like to find details about routers and the different types of routers. Is there something in ppt or pdf that explains the difference between edge routers and core routers?regards, Mark
Hi @Georg Pauwen thank you for your response. I followed your guide and I can no longer connect from outside to inside using RDP. I have carefully checked my edits.I do not use NAT, because I have a public class C behind the device that I use. This ...
Hi @paul driver thank you, this is exactly what I needed to get back on track. I think I was mixing two forms of packet access management.One minor modification is needed. I would like to limit traffic coming in to 3389, but I don't want to limit tr...
Thank you @Giuseppe Larosa and @Richard Burts The problem was the VPN setup, so I've removed the offending command that you helped identify. I also added the ACL to permit icmp to return to the router. Now I can use the routers diagnostic tool and i...
Thank you @Giuseppe Larosa Unfortunately, I cannot test as the router was replaced with the old router whilst I work out what went wrong.I've attached the two configs above, and will try to setup a testbed this weekend. Unfortunately, we have a covid...
thank you @Georg Pauwen I've copied the existing router config - it is a HP MSR1003-8and the ISR C1161X-8P config as it was the day I was trying to swap out the old router. Before I try to do the swap again, it would be great to work out what went w...
