Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,we have a Web Server connected to the DMZ zone in Cisco ASA 5520, this ASA is connected to Two Cisco 3845 Routers each router is connected to a differnet ISP and there is BGP peering configured between the ISPs,also there is HSRP configuration ...
Hi,we have 8 HP blade switches connected to core switches with Etherchannel, the power was down two days ago and after it came up again and after all network devices started, we found that the port channel was down between all the blade switches and ...
Hi,we intend to implement websense as our filtering solution but without integrate it with Cisco PIX or ASA so it will be a Standalone installation.we will use SPAN ports to copy traffic goes to our ASA and Send it to Websense Server then if the traf...
Hi,we have cisco 6509E core switch with CSM-SSL instlled, it's version was 12.2.18 SFX.after upgrade the ios to 12.2.33.SHX we couldn't open the csm and we coulding reach our servers that used behind the load balancer.please any advice regarding this...
Hi,we have a cisco based network, we want to configure dynamic routing protocol so which dynamic routing we should use?, OSPF or EIGRP.also what is the advantage and disadvantage of both routing protocols in practical experience.Thanks
Hello,Thank you all for these useful informations.As you mentioned, it is difficult to have Load deistribution in two routers with two differnet ISPs beside the problemsthat will be faced if we use this technology.we configured the ASA to distribute ...
Hi,Thank you amit, this is the show standby output:=======================Primary router:GigabitEthernet0/0 - Group 102 State is Active 28 state changes, last state change 4d18h Virtual IP address is 172.16.101.5 Active virtual MAC address is 0...
Hi,Thank you all for these useful informations, it is really confusing when tring to choose the best routing protocol but i think that if the network is cisco based and there is no intension to change or add any other vendor then it is better to choo...
