Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am trying to build one IPSec tunnel where i am using the Multilink interface as a source on my end router.But i am unable to build this tunnel up.Now i have doubt like whether we can build IPSec tunnel on multilink or not?If we can configure the...
Hi,What could be the reason for the following Symptom.Interface Status:- Down.Interface Line protocol:- UPHas anyone experienced such type of problem? If yes please share.Thanks:Ajeet
Hi Friend,You can allow the peer IP's like following commands. Moreover if you can provide the information regarding the setup like how you are securing your GRE traffic over internet or the brief connectivity setup.Following commands may help you.ac...
Hi,You can check the load of the interface with the help of "Show interface" command.You can find the Rx & Tx of the interface.Please rate if it does help.Thanks:Ajeet
Hi,In a first look it seems there could be loose contact or might be the ethernet port has gone bad.You can use "debug fastethernet {events | packets}" command for more information.Please rate if it does help,Thanks:Ajeet Kumar
Hi,You can use "show version" command to know the IOS image. The output of this command provide you some more information related to your router hardware.Please rate if it does help.Thanks:Ajeet Kumar
