Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to put a firewall device between a server load balancing (SLB) device and the real server(s). SLB uses Direct Server Return (DSR), in which case the VIP address is configured as the loopback address on the real server. Simply, the reason for t...
Hi All,I need to upgrade my 2948G switch from catOD4.5.9 to catOS8.9.x. I have 12M of flash with almost 8MB of available space. Software advisory reports that catOS8.9.x requires at least 16MB of flash. However, the actual file size of the new image...
Hi All,PCI requires SSH access to networking devices. I have following questions regarding to that:1) I have IOS IP image on my cisco routers. I found that I need 3DES support in IOS for SSH, which comes with IP Plus 3DES feature set. So, do I need t...
Thanks for the suggestion, but my understanding from your explanation above is that it would stop arp replies for all static NATs defined for that interface. This is not what I want. What I want is to have proxy arp for some NATs (for the real IPs), ...
Yes, I believe routing is not an issue in terms of my configuration. I have a load balancer device in front of PIX to load balance some services on the servers protected by PIX. I have static NATs for the real IP addresses of the servers. Yet, I need...
