We have a couple of 6503 switches configured for SNMP. Two of them are being discovered by NetHealth while the other two aren't. The SNMP strings are the same and the remote IP is allowed in through ACL. There are matches on this ACL for this part...

We added a new vlan (vlan5) in an FWSM context with "nameif inside1" and IP address of 10.10.1.1 mask 255.255.255.0. Routes are set on the router. The interface and line protocol are shown as down. A "no shut" does not enable the interface.Help? ...

In some of the ping lines from "ip cache flow" shows "print" for scrp. I typically expect 0, 3, or 7 here, but have never seen "print" until now. What does this mean?Thanks.

I'm looking into upgrading the FWSMs from 3.1.4 to 3.1.5. Cisco documentation (http://ftp-sj.cisco.com/cisco/crypto/3DES/lan/catalyst/6000/fwsm/c6500fwsm-releasenote.3-1-5.pdf) seems to say that I need to have SXF IOS image on the 6509 to upgrade. I...

Hi, module 3 of one of our 6509s shows cf:4 as its boot location. This module had failed and had to be reloaded from cf:4 which is supposed to be the default application partition. The other 6509s that have not had a module failure this way has no ...