Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,i?ve got some trouble on my switch. Unfortunately I cleared the nvram. Now there is no IOS inside the switch.I?ve read a lot of documetation, but I cannot load the original IOS Software, which I have saved first (I?m so glad about that) on my C...
Hey Paul,unfortunately the posts stoped here. As I was following the entire discussion, bc I have the exact same issue. Small difference: I came from a 2504 and switched to a 3504. I cannot bring AirPrint to life and event adding a new device to my ...
Hello Mohammed,i found something out on the cisco Support:The booting process of the Catalyst 2948G-L3 and the Catalyst 4908G-L3 is very similar to the booting process of other Cisco IOS routers. One issue is that prior to bootstrap version 12.0(7)W5...
rommon 9 > devDevices in device table: id namebootflash: boot flash eprom: epromrommon 10 > dir bootflash:device does not contain a valid magic numberdir: cannot open device "bootflash:"rommon 11 > dir eprom: File size ...
