Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have two 1310 bridges which im trying to configure. Ive had them working a long time ago, but they were reset recently and need reconfiguring.I followed the Cisco guide for a point to point wireless bridge however I continue to get an error ...
Hi drgebhardt,Sorry for the delay in response, and thank you for the reply.The units were reset to factory defaults, however I have not tried setting up the non-root first.I'll give this a go tomorrow when I am able to get back to the units.Greg
