Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know if there is any way to get CiscoWorks to back up the running config of an ATM Blade running on a 6500 series chassis? I played around with netconfig, but it seems to fail during the "session" command.Info:6500 Switches (6509 and 651...
Hello all, I'm somewhat confused on something that seems straight forward, but my brain isn't getting it. I have a PIX 525 running 6.2.2. We use the inside and outside interface as well as 4 "DMZ" interfaces. The security levels are set somethi...
Hello all, We're doing some testing of wireless networks here at my site. We have jumped on an all Cisco solution for now. For the sake of testing we are running 3 different configs using the following hardware:Cisco Aironet 350 APCisco Aironet 3...
I had opened a case with Cisco way back in January on this. They did not update their file from November 2003 to May 2004. I sent a nastygram to cisco saying they should update it or remove it. Either way, here we are in June, and it still reads M...
No - RME does not recognize this. I knew from theoutset that RME wouldn't work "out of the box", but I was hoping that I could send netconfig commands to the Sup2 that would allow me to sess into the ATM blade and download the config.I'm not dead in...
Unfortunately it is not like the MSFC. The blade is ATM...there is no IP address to it. The only way to manage it is to session into it through the supervisor (as far as I know).
