Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a switch which I think has it's mac address table been flooded. I ran two different sniffer software which showed TCP traffic for different hosts/ports on the switch which I am not suppose to see since I had no span enabled on the switch. Is ...
Here is the output of a sh spantree active : Why there are two different cost of 19 and 100 ? I noticed that 100 is connected to 10 MB/ half duplex devices, where the 19 is connected to 100MB full duplex. Why ?Any input is highly appreciated ?Thanks...
Here is an output for a sh port on my switch for one of the ports I think is having problems (Collision).Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize----- ---------- ---------- ---------- ---------- --------- 2/40 - 0...
In one of our switches,the broadcast address is set up to 10.6.0.0. I Was reading and comparing it to differenent Switches which had the Broadcast 10.1.255.255Does 10.6.0.0 broadcast on the switch affect the switch ? If so Can I just change it by :s...
Existing setup: A wan Frame Relay network through a providoe (Sprint) in which sites A and B are the hosts for several remote offices C, D, E, & F.All PVC's are configured between Sites A and B and the rest of the remote offices (Meshed network). The...
Thank you so much for your reply. Here is the utput for sh vlan :Console> enEnter password:Console> (enable) sh vlanVLAN Name Status IfIndex Mod/Ports, Vlans---- -------------------------------- --------- ------- ------...
Thanks for your help. I am researching the meaning for the sh port :Port Single-Col Multi-Coll Late-Coll Excess-Col Carri-Sen Runts Giants AND Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize. Example : Single-Col , Multi-Coll, Excess-Col But ...
it is an ethernet 10M half duplex wouter (gateway for the LAN), but it is configured for speed 10 half duplex to match the switch port which has :Console> (enable) sh port 2/40Port Name Status Vlan Level Duplex Speed Type---...
So, Do I need to set the broadcast address or not in the following command? or it learns it automatic ?int the set int sc0 10.6.0.3 255.255.0.0 The output from my switch for sh int :Console> (enable) sh intsl0: flags=50 slip 0.0.0.0 dest 0.0.0...
I ment utilizing two T1 lines for internet access.Currently only one providor is used through a 2600 Router to a PIX515 to another default gateway 2600 router for the internal private network.I have some VPN users hitting the PIX for internal access....
