About JohnNevruz

JohnNevruz · 06-17-2012

I am having an issue with landing and inbound call through MGCP gateway to IP Phone that belongs to a partition 1ST-PT:PSTN->E1->2811->MGCP->CUCM 7.0.1->IP Phone1) As soon as I take out IP Phone from it's partition into <none>, inbound call lands jus...

JohnNevruz · 06-02-2012

Hi,I am trying to configure router on a stick with 2811 and 3750, but I just cannot get it to work - vlans are not getting propagated from 3750 to 2811:3750:interface FastEthernet1/0/48 switchport trunk encapsulation dot1q switchport trunk native vla...

JohnNevruz · 06-17-2012

It seems I found the issue. MGCP E1 Port configuration does not take any changes for CSS even if I restart/reset the gateway from the same page, so gateway remained all the time in CSS = , and was able to reach only phones outside all partitions. Sh...

JohnNevruz · 06-17-2012

DN is in 1ST-PT, 1ST-PT is in GW-CSS, and MGCP E1 Port is attached to GW-CSS. DN Analyzer shows that everything is fine and that DN should be matched with inbound call. I could not find any overlaps, overall config is very small.

Member Since	‎06-02-2012 10:32 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	4

User Statistics

User Activity

Gateway CSS issue

Router on a stick: 2811 with 3750, not propagating VLANs

Re: Gateway CSS issue

Gateway CSS issue