I have two cisco2948g-l3,here I marked as A and B.And they are all worked after configured.Now,I found that switch A's Command Line appeared bad characters by console.But Switch B is Ok.I do nothing to my PC.(9600,8....)As I use another PC,two switch...
Our comapy have a pix 515,it was behind in cisco3620, now I need build vpn with our 40 partner located at whole country.How can I do?What's the influence to performance??
I configured three vlans on catalyst2950,between 2950 and cisco3620,there is a pix 515,So could I make all of three vlans go to internet?If there is pix,i can configure subinterface on router,but now,how can i do?
Thanks for advice.But in fact,all of the ports I used were needed to be mirrored.Then how can I do?someone told me there is no other ways but use 2924 or others instead.
