Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I need to change the source IP of a packet for one of my NAT'sI currently have an Cisco 1812.I have an PPPoE connection as Dialer 0.I have another VLAN that is connected to an Netscreen SSG5 VPN gateway via another Cisco switch.I have a vlan trunk...
Hi all,I've got a sip client that I know works fine (tested with another modem/firewall).Since moving my access across to a new 1812 I can no longer hold up a SIP session.The SIP device sits in a DMZ but according to the logs its still getting droppe...
Hi all,I am very new to Cisco, and routing/ firewalls in general.I brought my self a Cisco 1812. Its connected via Fe/0 to an ADSL modem in pure bridge mode. So the 1812 is doing all the PPP auth.I've been following this guide Zone-Based Policy Firew...
RESOLVED!I set Vlan 50 and Vlan 10 to have "ip nat enable"I removed "ip nat outside" on vlan 50I added the following to translate the sourceip nat source static 192.168.0.2 10.27.30.226Now it all works. Only from 192.168.0.2 as expected.Not sure how ...
interface Vlan50 ip address 10.27.30.226 255.255.255.248 ip nat outside ip virtual-reassembly zone-member security LANNo helpStill can not ping an IP address from a machine on my network to the VPN
Config attached.#sh ip routeCodes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 ...
