Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a problem getting the address 68.212.76.6 socket number 10001, through to the 10.10.4.x address in this switch. At the switch and station level I can ping the address, however I can only telnet to the port when logged into the switch, not from...
I have an network that has 172.17.0.x as the main backbone, and I have a couple of buildings that I need to have DHCP client PCs installed. I have a 3650 to use for the building and everything on the backbone is statically routed. I would like to hav...
Basically, my problem was I posted a config that was not working, and was wondering why it was not working. The config I posted is in the initial postings. Below is the final config that does work.Current configuration : 2418 bytes!version 12.2no ser...
Hi, l ThotYes there is a route in the 172.17.0.x router to indicate a route as spcified.So if this is the case is the basic config file one that should work or should I be changing something?
This is the connection to the 172.17.x.x. So just like a router I thought you make the vlan virtual interface as a regular address then have the default route go to the 0.1 device. Is that the way to do this config?
That is correct.The main backbone is 172.17.x.x/24. I am trying to get 10.10.1.x on the switch and the outside traffic through the 172.17.x.x network to the outside.
