Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a question regarding the PIX 501 and 506e using PDM. When I first set up the device I am able to connect through PDM using the default settings, however when I change the internal IP interface and configure the laptop I?m using to utiliz...
Hello, I had a question regarding a PIX 506e firewall and a Catalyst 2960 switch and setting up internet access. Everything worked fine before I decided to subnet the internal network, I had it set up so the internet can be used and RDP can be passed...
Hello,I had a question regarding a PIX 506e firewall and a Catalyst 2960 switch and setting up internet access. Everything worked fine before I decided to subnet the internal network, I had it set up so the internet can be used and RDP can be passed...
The question I have is regarding the PIX 506e v6.3 and trying to configure RDP to pass through. Scenario: External IP address 10.1.0.23, internal 192.168.7.23. Permit Rule source 10.1.0.23 Dest. 192.168.7.23 It builds a translation rule but wants to ...
Here is the scenario, I will try to describe it the best I can without confusing anyone. The current network I am building has been sub netted to the following;Domain Controller 1: 192.168.7.5 / 255.255.255.240Domain Controller 2: 192.168.7.6 / 255.2...
I followed your advice, but it still doesn't want to work. I tried it both in the PDM and reset the pix back to factory defaults and used the CLI with the following commands:static (inside,outside) 192.168.7.23 10.1.0.23 netmask 255.255.255.255 0 0ac...
