Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have these cards in a distribution Cat6500: WS-X6348-RJ-45I know that they are quite old and that they do not have a priority queue (Rx: 1q4t Tx:2q2t) However could we configure a basic QoS strategy? May be we could configure one output queue for v...
I have a small project to authenticate around 100 users to access the network. We are planning to use the Cisco NAC appliance. Just to clarify (I have seen some post but I am not sure of the right answer) Do I need 2 separate appliances, one as serve...
I need to replace an old router that has 8 serial V.35 interfaces. I think that a 2800 would do the trick but I am not sure. Any suggestions?Thanks,-as
I have a strange problem with a service-policy in a 4503. I set up the policy to rate limit all traffic with DSCP AF21 to 8 Mbps. However when I apply the configuration instead of give me 8 Mbps it rates limit the matching traffic to 200kbps or somet...
What are the architectural differences between the WS-X6748-GE-TX, WS-X6748-SPF and the WS-X6724-SPF (ports per ASICs, buffers Tx-Rx, fabric connections, etc.)? Also, if someone has information about the oversubscription rate of the cards it would be...
Hi, Also, I forgot to mention. Try to boot just with the supervisor. Remove all the cards but the supervisor. If it is a HW problem in any of the other cards you may be able to boot.-as
Hi, I found in PDF an old procedure to reset passwords. It says the same about the "no-password" during the first 30 seconds.http://www.net130.com/technic/password/pswdrec_6000.pdfIt is weird that it never prompts for a password. Have you tried to e...
If I remember well, during the first 30 seconds or the first minute the 5500 has no password. So login in the console, after the password prompt just type enter. You must have access to the main CLI, type enable and enter.Now, as enable user change t...
