Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am currently working on the E1 leased circuit. The circuit is between Karachi and NewYork. Loop has been extended towards Karachi from the T1 side of the converter at NY. But I am unable to detect the loop on the router!My controller configurations...
Many a times it has been observed that the customers complaint that their line protocol is down. Apparently every thing is fine but when we extended the loop it is detected at both customer and the service provider end. As soon as we through the circ...
Currently I am pinging an IP Address but getting the A! response. Could any body tell me what configuration have probably been implemented on the remote network router?
I am getting the loop from the New York E1 side of the converter. but not from the T1 side of the controller.Regards,Kashif Siddiq PatoliPak Telecompatoli@pie.net.pk
I have tried many options but the situation is still the same. The telco is not very much supportive and time difference between Karachi & NewYork is further contributing to our miseries.Regards,Kashif Siddiq PatoliPak Telecompatoli@pie.net.pk
Thanks. Your reply solved my problem as required. I hope you will extended such favours in future.Kashif Siddiq PatoliAssistant Divisional Engineer,Pakistan Internet Exchange,Karachi Pakistanpatoli@pie.net.pk
