Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Steve,Please see inline:"So SSH traffic from 10.10.10.0 addresses would be ignored and all other would be policed and dropped if it exceeds the traffic rate." [BD] Yes, that's correct - however by ignoring the 10.10.10.0, this just means that it wil...
The ASR's architecture (RP, ESP, SIP, etc) and SW feature support is a little different than the 6500/7600 where you would normally use the local span feature. The command was removed in later versions of code to avoid confusion.ASR1k(config)#monitor...
Hello,Here is a very good document on CoPP Best Practices, with Policy Construction and examples.http://www.cisco.com/web/about/security/intelligence/coppwp_gs.htmlPlease review and let me know if you have any questions.ThanksBD
Hello,
Please see below.
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/lanswitch/configuration/xe-3s/asr1000/lanswitch-xe-3s-asr1000-book/lnsw-conf-erspan.html#GUID-152D9875-169B-461F-A34B-ABAABD0C1FF8
"The monitor session span-session-number typ...
Hello,EEM can certainly be customized to meet the needs that you've described. Using event ipsla, with other various config options can accomplish this, but would take quite a bit of customizing.However, the scenario you've used with the ISP bouncing...
