Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently have two 3500XL switches with 10 VLANS in HSRP mode. These Switches act as a backbone to other 3500 switches which service our servers. Each 3500 rack switch has a port designated to each backbone switch for redundancy. I recently attem...
I noticed on yesterday that I am receiving the following error on my 350 series switch.STANDBY-CLUSTER_MEMBER_3-3-BADAUTH: Bad authentication from 1.2.3.4, remote state init.While everything appears to be working fine, I am wondering what is causing ...
I am attempting to use the the RSA RADIUS server with Cisco AAA. configured as followsaaa new-modelaaa authentication login default group radius enableaaa authorization exec default if-authenticatedaaa accounting commands 15 default start-stop grou...
I am currently running BGP between 2 ISP's over HSRP between (2) 2621 routers. I have HSRP setup between the 2 routers as well as tracking of the Serial interfaces for failover. This seems to work great in the case of a T1 failure or a router hardw...
Can you explain from my config below?Router A!!interface FastEthernet0/0 ip address 1.2.3.3 255.255.255.0 no ip mroute-cache duplex auto speed auto standby 1 ip 1.2.3.2 standby 1 priority 105 standby 1 preempt standby 1 authentication foobar!interfac...
