You have to configure the bridge port to route IP.bridge x route ipshow bridge x - tells protocols bridged/routed

multilink virtual-template 1!interface Virtual-Template1ip address w.x.y.zppp multilinkbandwidth xxxx This will create a multilink interface that you have to set the bandwidth too for EIGRP.EIGRP, being a link state protocol, will use 224.0.0.10 to e...

Get your hands on an 8 pin rj48c cable (rj45 works too).Pin outs are 1-2 cross over to 4-5 and vice versa.Plug and go...If you have integrated WicT1 DSU in them, just setup on each router:router(config)# controller t1router(config-controller)#linecod...

I would setup loopbacks for the tunnel source interfaces and then add to ISIS routing process.Assuming you cannot add loopbacks to IP cloud though (cause you dont have access), source tunnels from external most interface IP addresses.-------R1:int s0...

Not sure which switch is indicating the native vlan mismatch, but here's a high level overview of whats going on...With the 802.1q trunk specification, vlan1 is the native VLAN that carries the tagged VLAN data between switches. Sounds like this has...