Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are running DCNP 10.4.1, deployed via an OVA on VMware. We just moved the VM to our new data center and need to change the IP address, gateway, subnet, and DNS. I have looked at instructions which said to modify installer.properties, but this di...
We are setting up a connection between our primary site and a replication site. I have setup a router at each site and they connect via a T1. I now have connectivity between the two sites, but I want to implement security between the two sites to l...
I am pretty much a novice as far as router configuration goes. We have just purchased two Cisco 1841 routers with the T1 interface. I have them configured, but am trying to test the communication between the two routers before shipping the one to t...
Thanks for the help. OK. Telnet is working properly right now, although I must say I'm not confident that I can pull off the rest of the ACLS to restrict it the way I want. I'm not sure if I need to put the ACLs on both routers, or just one and wh...
Yes, that was just a cut from the wrong place.It is:access-list 102 permit tcp 192.168.1.0 0.0.0.255 192.168.15.0 0.0.0.255 eq telnet access-list 103 permit tcp 192.168.15.0 0.0.0.255 192.168.1.0 0.0.0.255 eq telnetI see that in one you have the eq t...
So are you sayng that I need to add something like:access-list 103 permit tcp 192.168.15.0 0.0.0.255 192.168.1.0 0.0.0.255 eq telnetI tried this, but still can't get a telnet connection.Also, are you suggesting that it would be better for me to attac...
Thanks for the advice. I have tried to start out by applying ACLs on Network 1 on the Serial Interface, which does the routing. Here are the statements I have tried:access-list 102 permit tcp 192.168.1.0 0.0.0.255 192.168.9.0 0.0.0.255 eq 3218acces...
Thanks. I have made the modifications. When I posted the config on the web, I removed the username statements. That is why they were not there.As for the T1 controller, the card is a WIC 1DSU-T1 v2.
