Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here's what seems to be happening. My internet access is through a crappy Comcast Home Gateway. The comcast unit doesn't have any place to add routes. You can only set up one private address range and that is it. Behind that router is my little C...
Not sure where I slipped up, but when I try to load ASDM I get an unable to load ASDM from <ip address> message.wbdcfw# sh verCisco Adaptive Security Appliance Software Version 8.2(1)Device Manager Version 6.2(1)Compiled on Tue 05-May-09 22:45 by bui...
We are using an ASA 5505 in a small office LAN environment. When we try to run the update process on a postage machine (the machine connects to an ftp server to download updates) the process always times out with 0% transfered. I set a capture on t...
My client is a small non-profit that purchased an ASA5505 through the Cisco donation program. They want to monitor employee web access which was one of the capabilities described for the device. I tried to find out about getting a half dozen licens...
Unfortunately I only have one switch and one router in lab so far. My goal with this setup is to work on strengthening my grounding in the basics of TCP-IP.I think my best option at this time is to have Comcast put their gateway into bridged mode. ...
Yes, that is what I have learned after some research. Support for dot1q encapsulation was added to the 2610/2611 in IOS v12.2-2T. I had to upgrade the flash and add a second 32mb DRAM module before I could load that version.Roger
