We are working with a Trunking Gateway AS5400HPX in 12.4(13d) ios versionsThe HW is -AS5400HPX E1 8 PRI DFC-AS5400HPX NP50 / NP108 DFCThe configuration is done according isdn in the following wayisdn switch-type primary-net5!iua AS as0 xx.xx.1.90 99...

It should be very nice if somebody could help me to resolve the foolwinf problemI have change the enable password with the following commandconf t # enable secret xxxxconf t #exit#wrI have tried to connect after that, but unfortunately, there is some...

HelloI have seen the following on the TGW cisco A5850 / IOS 12.4(13d)(In slot 1 - This is a 24 E1 card)The state of the board switch between "Power Pending" // "ROMMON"#sh chassisSlot Board CPU Proc Memory I/O Memory State ...

HelloWe use à AS5400HPX HW with the following cardslot 1 NP 60 DFCslot 7 E1 8 PRI DFCthe ios is 12.3 basedThe configuration of the gateway is for working in H323 protocol with specific dial-peers for the calls depending on the services.Form point of...

AS5850 Cisco IO12.4(7c),The used protocol is MGCP with a call agent. the behaviour we want for the gateway is to be able to have fax transmission in G711 codec without nse - without t38The mgcp parameters are on mgcp sideMGCP Admin State ACTIVE, Oper...