I've done a fair amount of googling, searching the IronPort KB as well as these forums and have not found a specific Voltage setting for powering the C150's. I've found references to Amp draw at different loads as well as an older document for a C10...

looking for a method to have a C150 relay mail through another C150 if it is unable to deliver outbound messages to the internet (ie. looses internet connectivity in one of our data centers). Each device is in a seperate data center with seperate In...

I'm running a C10 with ASYNCOS 5.2. I just reset it to factory specs and started configuring the device. When I got through the network config anc clicked the commit changes it hung. I've had the device powercycled and I still can't reconnect to i...