Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I work with an ISP that has a cisco 1720 router to their backbone. I am installing a router on their network that will provide access to a local company via a PPP serial connection. There is a 1600 series router on both ends of the WAN segment. The 1...
I have a cisco catalyst 2924 and a xyplex 10/100 Switch. I cannot get a device on one switch to talk to a device on the other switch at good speeds.. As long as they are on the same switch (either one) they do just fine. The switches are connected t...
Haven't been hiding anything. But rip had been turned off a little before that, in order to try to figure out what was going on. So I had just reenabled RIP right before that. So that is probably why there wasn't any routing statements. I wouldn't p...
