Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've performed the steps exactly following the guide by Cisco (http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a0080af7d1d.shtml) to allow Junos based tacacs+ authorization but I'm strangely getting the 'servi...
I have a LMS 2.6 on Windows. Recently, I could not access LMS after logging in with a correct or incorrect password. I've checked on some similar netpro conversations and verified that the LMS can resolve its own hostname properly. I've checked th...
Hi Yudong,Your suggestion was spot on. I removed the tacacs+ as you mentioned, ensured the user/group has a new Junos-exec only service without the tacacs+, restarted acs service and it worked. Before that, I tested using tactest and entered junos-e...
Hi Yudong,It doesn't seem to have sent back the protocol=tacacs+ line. I will try to remove the tacacs+ as you mentioned when I get access to the juniper switch again. Looking at the log, should the METHOD be equals to TACACS+ as well?Thank you for...
I think I managed to recover a md.properties and replaced the corrupt one with it. However, I'm still getting a blank page but I believe this is something different as the url is stuck on a different address. The stdout.log gives out a different er...
