Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a PIX 506 running 6.3 with multiple VPN tunnels. On one we are attempting to nat two network to a single 192.168.30.10 and the other network to 192.168.30.20 as below. The nat is working and the tunnel is sending the traffic to the remote end...
I'm looking for any advice or suggestions on best practice for the task of upgrading from a PIX 525 running 6.3 to an ASA 5525X with IPS, the PIX is setup in active/standby failover and the ASA will be setup the same way. The PIX has been in service ...
I have a 2921 router directly connected to an Ethernet MPLS network, one of about 10 location all configured the same. This is a new install and has been tested by the LEC to be good however, even thought the interface below indicates to be up/up we ...
Jouni,Just to update, I never did find a reason as to why this configuration would not work on a PIX 506 running 6.3. However we purchased another ASA running 8.2 and I did the same configuration, same LAN topology and it worked first try. No clue as...
Hi Jouni,I'm still stumped, tried the config above and still no luck. It's really strange I can see from the crypto IPSEC sa results below that the packets are returning via the tunnel but the source gets no response. Below is exactly what I did, I h...
Thank's Jonui,I really appericiate your help.I'm not sure what you mean though, I found another post you helped on mentioning the static NAT but when I try it I get the following. PIX515(config)# static (inside,outside) 10.46.0.0 255.255.252.0 access...
