Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have the need to temporarily set up a table of computers on campus. Normally, we can connect an un-configured switch and it will pick up the VLAN configured on the upstream switch. We have a nexus core and all switches are in transparent mode. ...
I have an outside 7206 router that is configured with BGP. Behind that I have an ASA 5520 with a failover. Everytime my primary ISP goes down I have to failover the ASA to restablish a connection to the secondary ISP. When the primary comes back o...
I upgraded a Catalyst 2950 switch and there wasn't enough room so I deleted the flash. The upgraded went well using tftp. It booted up fine. The I0S version includes crypto. But, I can't access switch via web browser or CNA. Port scan shows port 80 ...
I could trunk both ports and add VLAN 4 to the downstream switch. It was just easier for the techs to deploy since its only for temporary setups. As I mentioned, a lower end switch like a Netgear will work that way without having to reconfigure ups...
Switch is unconfigured. It shows on primary. Here is show fail.LEE-ASA# show failFailover OnFailover unit SecondaryFailover LAN Interface: failover GigabitEthernet0/3 (up)Unit Poll frequency 1 seconds, holdtime 15 secondsInterface Poll frequency 5 s...
So, you thing there might be a problem establishing a route to new default upstream to the ISP that is still up? When I fail it over it get's a new route?
Thanks for your responses. Sorry, I'm new to this. Here are the configs and a simple pic of the primary asa and router the way thery are deployed. I've been dealing with issue for a while. Hoping to get some help here. 7206 router: show runnBuilding...
