Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiDownloaded the Ciscoworks QOS Policy Manager, installed on 2003 SP2Had an error free installation however everytime I try to run the Qos policy management from the Ciscoworks homepage I get the following error..."The QPM application is not fully st...
Currenlty have Ciscoworks LMS 2.6, ASA 5510/05, Checkpoint Firewalls, 4*6500 approx 300 3750's.Recenlty trialled ManageEngine Netflow, proved to be a life saver so money now available.Im looking to "sell" MARS to my boss instead of ManageEngine Netfl...
Create your vlans on the switch, apply the default gateway for each subnet to each vlan and add the helper address to each vlan as the windows server.Put the relevant ports in the relevant vlan and any devices which send a dhcp request will always be...
Could be barking up the wrong tree, though i would have thought the MSFC card would show as a daughterboard card under the sub-module section.Have a look at this document.https://www.cisco.com/en/US/products/hw/switches/ps708/products_qanda_item09186...
my show mod for the sup looks like this...CC-LC-SW1#show mod 7Mod Ports Card Type Model Serial No.--- ----- -------------------------------------- ------------------ ----------- 7 2 Supervisor Engine 720...
Sorry i thought that was the module port your supervisor was installed on...Could you do the same command for the supervisor port.The 15 1 1 you provided earlier indicates module 15 (ie there is no mod 15) which I think means you have a problem with ...
