Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am unable to ping my ISP default gateway from the 2911/K9. I have verifed the ISP connection by directly connecting the cable to my laptop with static ip addresses. Here is the running config and show version. Any help is greatly appreciated. Thank...
SW1 is connected to the router is a layer 3 switch and is doing intervlan routing. SW2 is a layer 2 switch and is conneted to SW1 via trunk link. SW3 is a layer 2 switch and connected to S2 via trunk link. Will SW2 and SW3 ip default gateway be 10.0....
What is the switching throughput for the WS-C3550-48-EMI? According to Cisco datasheet, it's 6.8 Gbps maximum forwarding bandwidth. Reason I am asking is because I currently have a CISCO2911/K9 as a router on a stick and it has a switching throughput...
For some reason I am unable to get o fut to the internet with my laptop. From the 2821 I can ping out just fine. I enabled DHCP on the 3550 and am able to pull a proper ip address. I also can ping the default gateway and router from my laptop but not...
Unable to configure laptop with that particular ip address and mask. I get an error "You entered an invlaid subnet mask. The subnet mask has to be contiguous. Please enter a valid mask."I have attached a WS-C3550-48-EMI to G0/1 on the router and enab...
This is very interesting. Are you saying that if you connect a PC instead of the router, and configure the PC with identical IP settings as the router, the PC is able to ping both the gateway address and any address outside?Yes.I have disabled CEF th...
and show ip routeGateway of last resort is xxx.xxx.xxx.113 to network 0.0.0.0S* 0.0.0.0/0 [1/0] via 24.43.239.113 10.0.0.0/8 is variably subnetted, 2 subnets, 2 masksC 10.0.99.0/24 is directly connected, Loopback0L 10.0.99.1/32 ...
