Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts, I have two interface dmz(S. level 90) and wan(s. level 60) i have two nat exemption rule nat (dmz) 0 0.0.0.0 0.0.0.0nat (wan) 0 0.0.0.0 0.0.0.0i have one another static nat rule:static(dmz,wan) 10.10.10.10 10.10.10.10when i try to removin...
Dearpls. give me url/ steps to resotre image and configuration of pix 525 runnung version 7.0 by tftp in monitor mode as it's not booting and going directly in monitor mode.i have copied all files in my tftp server but how to resotre this in monitor ...
Hi,I need to remove only an ACL entry from ACE which i created by adding network object in object-group.....i am not able to do same because all ACL having same line no. and ACL name.#access-list acl-in line 120 extended permit tcp object-group xxx-x...
Thnks for ur reply...now i got another major solution that is not documneted on cisco site, i taking confimration from cisco for same changes.now i am closing this coversation
i having so many acl with same configuration in diffrent object group so it's very tuff to remove from object-group then add acl in another object-group....
I can't remove from object-group because i allow traffic of same source>>>>diffrent destination ip and port.......if i will remove from object then all acl will be remove for that ip from object-group and other servers will be out of customer access....
