Hello, I am probably missing some finer point of either NAT or routing here. Here's the setup : (Internet)---T1---(1601)---192.168.1.0/24---(pix)---172.16.1.0/24---(3com Netbuilder II router)---10.x.x.x/16 customer subnetsHere is the problem: look ...
Hello,I recently ran into this problem: I have a 2611 that I can't use to connect to the ISP because the WAN ip address is dhcp assigned. The ethernet interface does not support the 'ip address negotiated' command.Is their any solution to this ? Per...
Hello, I am very much in need of some ISDN advice. I have a customer that can only get ISDN to the internet at his location. His requirements suggest he needs more than just a 128K ISDN line. My question is, can he get more than one 128K line and...
help! I have a customer that wants to connect some IBM AS400 terminals at 2 remote sites back to the AS400 at their main location. They each have a 256K frame circut from the remote site back to main. I am planning to put in a dual serial 1600 serie...
Hello, Is it true that you cannot NAT the ip address used by an interface on the PIX like you can on a cisco router ? We can only get one IP address from our isp. Can we still use a pix and NAT with only one ip ? Thanks!
yes, I follow what you are saying, what I ended up doing was taking the NAT off of the 1601 and moving it over to the PIX, with the appropriate global/static(inside,outside)maps.Everything worked fine after that. I would like to know, however, why I ...
typo in copying 1601 config: ethernet0 interface should read:ip address 192.168.1.1 255.255.255.0NOT : ip address (T1 public point to point #2) 192.168.1.1 255.255.255.0sorry !
