I have a PIX 515e with UR licence. When I enabled OSPF on the pix, the pix suddenly hangs intermittently. As soon as I disable OSPF, it returns back to normal. Any ideas on how to fix this. The pix has 64 Mb of RAM. do i need more?
I have just added 2 PIX firewall devices to the CW2K with RME 3.3.The firewalls are only being seen as Generic SNMP devices and not as firewalls. Configuration management does not recognize them.I have enabled telnet to the firewalls from the cisco...
I have 7 3524XL switches all connecting to a 4006 switch. When I launch cluster Builder on any of the 3524s all I see is just the switch as the commander and the 4006 switch. I do not see the other switches on the map, hence I cannot add them into ...
You will have to use the pix outside address to telnet to the pix or to connect via https. To be able to do this you will have to add the telnet and http commands specifying the ip address or subnets of where you are conecting from to the outside in...
Strange problem. Try setting the VTP mode on the old switch to server mode. Perhaps it was on client mode. If this was the case, the the new switches were probably overwriting it's vlan settings.Hope this helps.
you will have to put together an access-l on the inside interface of the firewall. It would be like this:access-list 110 permit tcp ipaddressinside netmask host ipaddress_1 eq wwwaccess-list 110 permit tcp ipaddressinside netmask host ipaddress_2 eq...
I am not quite clear on 1 or 2 things.what is the actual address of the device in the DMZ? If the device ip address is actually 200.1.1.5, then you do not need the static command. All you need is the access list. However, if the 200 address is a ma...
The hanging intermittently is just as you described. Running a continuous ping, it will timeout about 6 - 8 times and then reply 5 times continuously. However, at the moment it is running smoothly.