Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks,I am working on setting up VMPS on some switches. In the VMPS database configuration file, I know I can configure a "default vlan" through VMPS fallback. Is it possible to give the different ports the different default vlans? Such as config...
I am troubleshooting a wireless network. On some spots, the signal strengths keep changing between -58dbm and -72dbm. Nobody moving around when I collected the data. I am WirelessMon running on a HP laptop with internal antenna. Is it normal? please...
I just installed some new APs but my WLSE keeps sending error messages like this:Inconsistent device state found: Device "AP12": ifIndex=2, MAC=00-1c-f6-64-dc-50: "CISCO-DOT11-IF-MIB cd11IfStationConfigTable.cd11IfStationRole must be in the range [1....
Hi guys,I am setting up CCKM in my wireless network. I have several SSID on APs. Do I need to enable CCKM under all the SSID? Or I only need to enable CCKM under one SSID and wireless clients will get secure roaming ability for all SSID?Thanks!
Hi folks,I need your advices for my situation.The company I am working for has had wireless network but no staircases has been covered. All staircases are two type- 6-story and 3 story. I suppose I should put 2 APs on 6-story staircases- one on the t...
Thanks Dennis.We are using Cisco Aironet 1240 AP and Ant5959 antenna. I am a newbie and don't know how to exactly describe the RF environment I attached a diagram of the building. Basically, we are a hospital. I am having troubles on the red spots.
Thanks for replying.I am working on deploying Vocera wireless VOIP phone, which requires the signal strength to be more than 65dbm. On some spots the signal strength changes in the range from 58dbm to 72dbm so users get cut-off when they are talking ...
