Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is their a way to run the dubug command to see what is happening on a specific sequence number within and ACL?So for example if I have:Extended IP access list 101301 permit udp any eq ntp host 10.251.1.1 (12 matches)310 permit udp host 10.214.1.2 hos...
Hi everyone,I am having trouble getting DHCP to work across a trunk port. I have configured DHCP pools for voice and data on a Cisco 2811 router. I have on of the routers FastEthernet 1/3 ports connected to a port 0/23 on a Cisco 2960 switch. On t...
On an IPS is there a way to create a filter so that it will not trigger any signature based on a specific source IP?So for example no signature will fire for source ip 10.1.1.1
Thanks for the response but I was actually able to get it to work by changing the service-module ip address from 10.1.20.2 to 192.168.10.2 and creating a route.thanks for the respsonses
