Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am seeing the following status on T1 controller after test the circuit with carrier. But the serial interface show up. What does this means? why the controller showing the loop statusRouter>show controllers t1 1/1 briefT1 1/1 is up. (Line looped...
Dear All,i am looking for a command which can tell me all the ifindex assigned to interface in router. i know that there is one command in catos show ifindex but i couldn't find the similar command in router.please help.thanks
We confirmed with Telco and they have normalized the circuit already. But the same serial interface shows up and i could ping the neighbor end IP without fail.Thanks,Aru
Hi,When i execute the command, 6509-E>sh mac-address-table | in 5c00* --- 0014.f1fb.5c00 static No - Router* --- 0014.f1fb.5c00 static No - Router* --- 0014.f1fb.5c00 static No - Router* --- 001...
