Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,What I want to achieve is to give enable access to 2 different user groups (ie full rights) and NO tacacs is available.I require one user to have enable rights to one switch only, but at the same time give enable rights to the 'network communi...
Hi,We have a test network that is partitioned off the production network via a routed connection and ACLs. But a VNC session needs to be allowed from the test network to production network AND from production to test network.The ACL will have to be '...
Hi,I am new to Firewalls and I have to configure a 506E between the production (Enterpise) network and a new test lab. This is to ensure that any activities within the test area do not interfere with any operations on the production network.Both the ...
Hi Rick,Its sorted.The problem was (as you rightly alluded to)that I had previously configured login via tacacs and after getting it to work, I then removed the tacacs rule on the firewall (which had previously allowed tacacs port through). I then r...
Hi Rick,The config pertaining to this issue is as below.However, if we give a user a privilege of 15, doesn't this just mean that this user has access to all levels and therefore all commands, it does not mean that after they have been correctly auth...
Hi Kevin,The vty line is:line vty 0 4 exec-timeout 60 0 escape-character 3The username and password pair I mentioned earlier are under global command.regardsMark
Hi Rick,Yes I tried this earlier, but the user still has to type enable and then the appropriate enable password.The switch is running v12.2(25).The config I used as an example is:username fred privilege 15 password 0 fredWhen username fred and passw...
