Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi all,one of my cisco 837 router restarted on power failure and IOS failed.on console access i got rom-mon mode i tried to set back the config reg to 0x2102 and restarted then router booted to somthing unusual... like *** Soft loop.i restared a coup...
HI all,im using Cisco 877 (c870-advipservicesk9-mz.124-2.T2) at a locationthis location has a (last mile) radio bridge based internet connection (ethernet port)i made 2 vlans on the 877 Step 1 : Vlan database vlan 2 vlan 3 exi...
HI All, having a stange problem here.. i had a 2611 with 2 ethernet ports one for LAN and the other terminating on the ISP Internet device (radio bridge) it worked well i has setup a tunnel to the head office and PATTED for internet acess now we boug...
HI All,having a stange problem here..i had a 2611 with 2 ethernet ports one for LAN and the other terminating on the ISP Internet device (radio bridge)it worked well i has setup a tunnel to the head office and PATTED for internet acessnow we bought a...
Hi,i have 2 routers connected to the internet (live ip on ethernet interface)they both have different service providers hence diff ip pools..i need to connect them so the LAN on each side can access the other LAN .10.0.0.1(Router1)202.x.x.x INTERNET ...
hi,you can try this .. lets say your network looks like this.. net1--[SW1]--net2--[SW2]--net3network 1 is 192.168.1.x/24network 2 is 192.168.27.x/29network 3 is 192.168.3.x/24On SW1 do this.........................interface GigabitEthernet1/0/22 desc...
One more thing Edi,i did another test with an 837 (with 2 ethernet IOS) and thats working just fine.. could it be an ISP problem ???? if they r restricting vlan traffic or somthing..
it was a typo.. the funny thing is that i installed a 837 (which has 2 etherrnets eth2 mapped on fastethernet4 and ethernet1 mapped on fastethernet 1,2,3)and it seems to work fine...877 is giving problems with natting with 2 vlans defined as per my...
