Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I will be monitoring a few switches through SNMP. I will be monitoring the bandwidth utilization, packets dropped, collisions, etc. Is there some kind of industry standard for these statistics? I've seen less than 70% utilization on a WAN is co...
Hello,I'm trying to configure an ATA 188 but I am unsure of which image to use. Currently I have 2 2811's with FXS modules and analog phones attached that I am able to make calls between one router and the other without any problems. But I am unsur...
Hi,I am trying to set up a GRE tunnel to pass multicast traffic. Currently I have 2 routers back-to-back for troubleshooting, but there will be a WAN in between my two routers. I have a laptop hanging off of each 2811 etherswitch module. I am able...
Hi I have a 2811 router with a 16 port etherswitch. I have connectivity within the vlan on my switch but I cannot reach anything off of the router interface. Below is the basic configurations of my interfaces:f0/0 (Outside Interface) 192.168.211.1 2...
Brandon,I configured the incoming dial peer on Router 1 as (this the ATA gateway)dial-peer voice 300 voipincoming called-number 555000.But I still cannot dial the 555000. numbers from the ATA. I just get a fast busy. Are there any more parameters I n...
Brandon,The problem with the incoming calls on the ATA was indeed a codec issue. I've made some changes to my routers, and now I can dial from the FXS port on the ATA to the FXS ports on the same router. But I cannot make calls to the FXS ports on ...
Brandon,I setup the ATA with the h.323 image. Do I need to have an h.323 gatekeeper and gateway - I read they do not have to be setup. My ATA is on a switch off of one of the routers. I setup the other router's dial-peer to route calls to the numb...
James,I ended up testing multicasting using mping and another program I found on the internet. Both programs worked along with Iperf. I had the programmer check the TTL setting in the program and there wasn't one - it was using some default. Once ...
