Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,Good Day!I got an opportunity to present Cisco Meraki Security on one of our Partner's End User.There are some inquiries about Meraki's Security Solution:Is it possible to place a Bandwidth Limitation for Groups/VLAN's?In youtube, can Meraki ...
Hi Team,One of our Client's is requesting for an MS120 model. However it's not yet order-able in Cisco Commerce Workspace (CCW) since its will arrive this Fall of 2017.Is there a possible alternative if this is an urgent request?Thanks in advance!Reg...
Hi Team,I just want to know what is the most stable FMC version available in the Cisco Site.This is for ASA5545 model. I currently have 5.4.1-211 on my SFR module and 5.4.1.1-33 on my FMC.Thanks in advance!Kind regards,Enrico
Hi Guys,
Good day!
We have this problem with the FMC dashboard.
It stopped showing data.
One of our network tech restarted the SFR module while the FMC is still live.
This was for troubleshooting purposes why he restarted the SFR because there wa...
Hi Team,
Seeking for your assistance.
To start of, we recently purchased a Cisco ASA5525 with Firepower services.
The reason why we purchased this is to utilize the UTM features of the Firewall.
In our network we have a Juniper Firewall with expire...
Hi Guys,
I've done the following procedures:
>> Remove the registered Device under the FMC.
>> Removed the managers under SFR module.
>> Rebooted both SFR and FMC.
>> Applied managers and Device.
>> Reapplied the policies and others.
Traffic was seen...
Hi Jesty,
By the means of reboot the system. Meaning restart the SFR and also the FMC?
Re-registering the Firepower to the Firesight process is deleting the registered device and creating a new manager under the SFR module then adding the device agai...
Hi Jesty,
Good day!
Sorry it took so long.
I've followed your instructions about the "pmtool status SFTop10Cacher" and "pmtool restartbyid SFTop10Cacher".
It did not work, we even waited for more than an hour.
Previously the FMC was showing data bu...
Hi Jetsy,
Thank you so much for these information.
I will definitely give you feedback or I'll message again if I have any questions.
Kind regards,
Enrico
Hi Jesty,
Correct me if I'm wrong.
So under the FMC terminal.
sudo su -- for root user
then " pmtool status |grep SFTop10Cacher " will check the status.
What should I be expecting under the status? and what should I check?
Then this command " pmto...
