Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have problem with the following setup:I am using DMVPN (GRE, IPSec and EIGRP) in my network, tunnel interfaces on both routers are in the same subnet 10.64.24.0/22. Tunnels are up and functional. On R2 I have static NAT configured:ip nat inside s...
Hi I have problem with the following setup:I am using DMVPN (GRE, IPSec and EIGRP) in my network, tunnel interfaces on both routers are in the same subnet 10.64.24.0/22. Tunnels are up and functional. On R2 I have static NAT configured:ip nat inside ...
Hi,Suppose I configure IPSec VPN with certificate authentication for Cisco VPN client (during IKE phase 1),Cisco ASA is also configured with certificates from the same CA server and I am able to download CRL.IPSec VPN is functional.Later, I revoke VP...
HiI have a problem with Cisco ISR G2 2911 series routers. One of our clients has 50 routers in WAN network. All routers are totally new and in function only three months. BUT, three of them are DEAD. When I say DEAD I mean: they have no cooler activ...
HiI have a problem with 7206VXR CPU:7206A#show processes cpu sorted 1minCPU utilization for five seconds: 30%/2%; one minute: 30%; five minutes: 31% PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 281 8444700 705667898 ...
I do not have MPLS anywhere in my network. On leased lines I have HDLC on Layer 2 and OSPF asa dymanic routing protocol. DMVPN tunnels are fully functional, in case of router failure, traffic is rerouted over backup link (of course)But all that does ...
Primary links are leased lines and backup links are using Internet. I have DMVPN (GRE, IPSec, NHRP and EIGRP) between central routers and branch routers. On central site I use HSRP between R1a and R1b (for LAN gateway redundancy).On branch side i hav...
NaiduI have two routers on central location (for redundancy). R1a and R1b will have HSRP configured between them for LAN network. PC1 will have R1a as a default gateway, if R1a fails R1b will take over. Also, if R1a WAN link fails R1b will take over....
I forgot to mention, there are two routers on central location (R1 primary and R1 standby) so static routing and redistribution into EIGRP is not an option. Is there any kind of solution regarding ARP, proxy-ARP or something similar?Why ICMP does not...
