I went through the configuration and think all required components are in there.I would say that we should check routing.Error message means that packet recieved as per local policy should have been a IPSEC encrypted packet however it was a plain tex...
use a different IP pool(unsed private IP range in your network) and make sure that on the internal additional routing nodes you have route poining to correct terminal router.to be sure that I am working in the right direction enable RRI and try and p...
Please add the following initiating tunnel from either side:from router:debug crypto isakmp debug crypto ipsec from ASA:debug crypto isakmp 127 debug crypto ipsec sa 127after everyattemp please collect show crypto isakmp sa and show crypto ipsec sa f...
Hello,followin is the link that can help you probably:http://www.cisco.com/en/US/docs/solutions/Enterprise/WAN_and_MAN/V3PNIPmc.html#wp349808Regards,Mudit Jain
