Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys;I am configuring port-channel on my 2821 router but unable to do so.Remember its HWIC-2FE card.When I issue the command channel-group 1 below error comesError: This interface does not allow user-settable mtu.Remove the mtu command from the po...
Hi;am downloading 3825 security IOS there are two IOS of advance security, am confused what’s the difference in both Advance Security Image ADVANCED SECURITYc3825-advsecurityk9-mz.124-15.T7.binASK9-ASK9 FEAT SET FACTORY UPG FOR BUNDLESc3825-advsecuri...
Hi;I am going through very strange situation and very desperate why its happening. VWIC-2MFT-E1 controller is installed in my 3825 production router on slot 0, its 1st port does not work but 2nd E1 port works fine. Below is the output of controller E...
Guys;I have two routers and HSRP is running fine between them. I used to make changes on Active router during production but sometime forget to implement changes on standby router which cause problem when failover occurs and it leads to very tense si...
Guys;My 2811 is connected with two ISP,s as below and have VPN with Central branch. /--------- one ISP (ebgp neighbor) 256 Kbps WiMaxRouter 2811 \----------2nd ISP (default Static Route) 512 Kbps ...
Hi Steve,I apologize for my above post which I have edited as well for readers of this forum.I made mistake and asked you to change the proxy port from 8080 to 80(which is web server port).Your scenario is complex because of some limitations. Hey eve...
Okay; Boss I must say you have very complex scenario, while you can use one to one PAT but this option might will not work on Cisco device. Anyway try this if it works or not (I ma not sure)Enable ip nat inside and ip nat outside on respective interf...
Hi Steve;I remember, i hv run same scenario in my last job of ISP; to achieve this objective my proxy port was 8080 and redirections was made in linux proxy from 80 to 8080Below are the configurations of route-map.route-map ProxyRedirect permit 10mat...
