Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI All, I am running a 1841 Branch router as an EZVPN hardware remote in client mode so very simular way the software clients work, below shows theCentral OfficeExternal Interface address is a public IPInternal Interface Subnet 192.168.128.0/24VPN Po...
I have just configured a 1841 router to connect to our central office as a hardware client in client mode, normal internal traffic works fine but when i try and access the subnet in the central office i get the following in the debug output.the stran...
Hi All, I'm really struggling in getting this up and connected, i have attached some configurations and copy and pasted some info below if any one has any suggestion pls help.----c1841#show crypto session Crypto session current statusInterface: FastE...
Hi All, I have a problem where internal hosts cannot access an internal webserver using the routers extrenal interface address which is forwarding to the internal webserver.If Client1 browsers to xxx.xxx.xxx.xxx then the port redirect works fines, bu...
Hi All,I am trying to configure an old PIX 515e i have brought this up to pix804, I would like this to run in transparent mode so i dont have to reconfigure the network.It currently sits with the switch on the inside interface and a ethernet dsl mode...
Hi Teddyhere is the config.!! Last configuration change at 11:44:32 UTC Sat Feb 1 2014 by rootversion 15.1service timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostname xxxxxx!boot-start-markerboot-e...
HiYes and that works, but when the VPN goes down and reconnects that change is lost as this particular access list seems to be generated by the VPN when it is established.RegardsSent from Cisco Technical Support iPhone App
Hi Teddy, Thanks for your reply, i would prefer to use the router in ezvpn client mode as this keep the branch seperate as all traffic nats through the assigned address from the ASA.Direction of traffic ------->172.16.32.0/23 (L3 Switch)10.255.255.25...
for some reason the above config has just started working!I just have one problem left that it seems to generate a access-list on the router shown below.Extended IP access list xxxx-CC_enterprise-list 10 permit ip 10.255.255.240 0.0.0.15 any (12 ...
Hi There, Here is the config !! Last configuration change at 11:44:32 UTC Sat Feb 1 2014 by rootversion 15.1service timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostname xxxxxx!boot-start-markerboot...
