Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been using PIX with command line for some time now.Since recently we upgraded to 6.3(3), I have been asked to use the PDM.Does anyone has comments using PDM? In addition, I was told that PDM adds additional config lines. If I wanted to use CLI...
I am planning to migrate from Conduits to ACLs, and I am interested in knowing the order of operation.Lets suppose I have access-list on the outside interface that allows HTTP & HTTPS packets to the Web server; however, on the DMZ interface I am only...
Cannot connect PCs and Printers using 10BaseT on Cat. 3548XLI have been trying to connect old PCs and HP printers using Catalyt 3548XL, but I have not been successful.I am using folloing configuration:-Speed: 10M-Duplex: half(NO auto on BOTH sides.)...
Andy / Jonathan,Thanks for the reply. I will definitely use only the command line, which I am comfortable with anyway. (I was asked to use the PDM because there are also some Checkpoint guys who are not familiar with PIX’s CLI.)I just started using t...
Using "static" command creates permanent entry in the translation table for the server.So, I do not understand why you would need additional "NAT / Global" command.You would need to allow access on the inside interface's access-list.
Thanks Scott.That was the exact answer I am looking for. I do not want any traffic going out from my Web server, but I want clients to be able to connect via HTTP and HTTPS.Thanks again.
