Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to change the cam aging timer on a Cat 6509 with S/W 7.3.2. I am trying to change it on one vlan and when I do it allows me to do it but then reverts back to the previous setting. It is set to 15 seconds at the moment and I am trying to c...
I have 2 CSS11501's configured with redundancy between them. On certain occasions I am noticing that the master is becoming the backup for a very short period of time, I think it is due to the fact that CPU utilisation on the master or backup is gett...
Are there ways of setting maximum TCP Session lengths via the Content Switches. I have an issue with a Switch that receives a normal packet of data in and then seems to transpose this into a TCP Reset and delivers it to the destination and also then ...
When I plug a 5483 GBIC into an 8 port Gig card (WS-X6408A-GBIC) on a 6509, I get 'Unknown GBIC' reported by the switch. I have checked the compatibility matrix and they should be ok.The GBIC's have been replaced and tried across different 6509's but...
Yes I am trying to prevent Unicast Flooding. The syntax I am using is 'set cam agingtime dyn 2 14400'. The command is accepted by the switch but the actual output displayed from a 'show aging' will change from 15 seconds to 14400 seconds and vice ver...
Thanks for that Zach. I have tried it and the command works on one css but not the other. I get message timed out after hitting d to display data. One css is on version 7.10 build 102 (the one that gives message timed out) and the other is on version...
